Netgear releases new firmware version for its WiFi range extenders. The users can update the firmware of their Netgear range extenders easily by accessing the www.mywifiext.net setup page. The firmware updates are very important for range extenders to function well. The reason being, performing Netgear extender firmware update fixes major bugs and technical errors that come across while using the device. Additionally, latest firmware updates add new features and enhanced security to the extender. In short, the overall performance will be improved by simply updating Netgear extender’s firmware.
However, sometimes, users complaint that after performing the Netgear extender firmware update process correctly, their device stop working suddenly. If you are also experiencing the non-working of the Netgear extender after updating the firmware, give the troubleshooting tips provided in this post a shot.
Here, we will provide you complete instructions on how to fix Netgear extender not working after firmware update issue in minutes. So, without much delay, let’s get started!
Fix 1: Restart the Extender
Technical issues are one of the first and topmost reasons that are making your Netgear range extender not working well after firmware update. Need not to worry! Such technical issues/ glitches can easily be resolved by simply power cycling or restarting the Netgear extender.
To restart or power cycle the Netgear extender:
First of all, disconnect all the devices that are connected to your extender’s WiFi.
After that, turn off your Netgear WiFi extender.
Let the extender take rest for 10-15 minutes.
Turn on the Netgear device.
Connect the extender to router.
Try to access the settings page of your Netgear extender using mywifiext.net web address.
Is your Netgear extender working fine after restarting? If your answer is no, then try the next troubleshooting tip highlighted below a shot.
Fix 2: Check the Connection
Your extender might not work after firmware update if there is unstable connection between the Netgear device and your router. To fix the issue, make sure to create a solid and secure Ethernet connection between your Netgear extender and router.
Apart from this, ensure that the Ethernet cable you have used to connect your Netgear extender and router is well-working doesn’t consist of any sort of damages or cuts.
Moreover, if you have connected your devices in a wireless manner, ensure that you haven’t used public or free hotspot for the same. Bar in mind – during firmware update and Netgear extender setup process, your device must be connected to your home WiFi only.
Fix 3: Check the WiFi Connection
To fix Netgear extender not working after firmware update issue, ensure that you have a high-speed and active internet connection. To confirm the same, run a ping test on your desktop or laptop. In the event that the ping test doesn’t give you the desired results, it means that you have a weak internet connection.
In that case, you need to contact your service provider. And, if the poor internet issue is from his end, ask him to fix it immediately.
Fix 4: Reperform the Firmware Update
Your Netgear WiFi range extender fails to perform well due to wrong or corrupted firmware version. Chances are that you have downloaded the wrong firmware version, resulting in the issue. To fix the issue, all you need to do is to perform the firmware update process again.
Access the mywifiext setup page or visit the official site of Netgear for complete Netgear extender firmware update instructions.
No doubt that regularly performed firmware update process helps in well-functioning of the device (if performed well). But, sometimes, the firmware version itself can become an issue for your Netgear extender. Fret not! You can easily deal with the issue by following the aforementioned troubleshooting tips. Just in case, you are still unable to cope up with the “Netgear extender not working after firmware update” issue, feel free to drop us a line into the comments section.