Coming across the Netgear router internet light amber issue has become very common these days. This issue has made the internet experience of a number of users go down the drain. However, the good thing is that troubleshooting it is possible. In case you are also stuck with the Netgear router internet light amber issue and would like to learn how to troubleshoot it, then it is recommended that you go through the solutions discussed below.
How to Fix Netgear Router Internet Light Amber Issue?
Restart the Netgear Router
The easiest way to fix the Netgear router internet light amber issue is to restart the Netgear router. Restarting or rebooting the networking device is very easy. In case, you still need help to execute the process, then read the instructions given here:
- Hit the POWER button to turn the router off.
- Disconnect the router from its electrical outlet and let it stay idle for 30 SECONDS.
- Now, plug the router back into its wall socket.
- Press the POWER button again, but this time, to turn on the router.
Although restarting the wireless router will help you to resolve the Netgear router internet light amber issue, on the off chance, it does not; it is recommended that you also restart your modem as well as the computer.
Check the Cable Connection
Another reason why the internet LED located on your router is blinking amber or orange is because the Ethernet cable connecting the router to the modem is worn out. To take care of the problem, you need to tape up the existing cable. Usually this stops the blinking of the amber LED light. In case, it does not, then you need to opt for a new Ethernet cable.
After connecting the networking devices with the assistance of the new cable, ensure that the connection is finger-tight. If you leave the connection loose, the LED light will turn to red indicating that there is no internet connection at all.
Bring the WiFi Devices Closer
Is your Netgear router kept in one room and the modem is kept in another? Nodding your head in yes? Well, in this case, you need to bring them closer. The reason being, too much distance between the networking devices can make it difficult for their signals to get transmitted properly thereby forcing the internet LED to flash amber.
While bringing the devices the closer, make sure that you are not pulling them too close. Otherwise, the signals emitted by them will end up clashing. And if that happens, then you will get stuck with more technical issues in the future.
Call the Internet Service Provider
Chances are that the Netgear router internet light amber issue is because your Internet Service Provider is not focused on his job. In this case, you need to call him up immediately. Does he agree that the internet issue is from his end? Yes? Well then, request him to get it fixed without wasting any more time.
Once things are normal from the end of your ISP, check if the internet LED on your networking device has stopping blinking amber. In case, you are still stuck with the same issue, then your last resort is to reset your router.
Reset the Netgear Router
In order to hard reset your networking device, you need to follow the step-by-step guidelines given in this section. It is highly suggested that you do not skip any step.
- Look for the RESET button located on your router.
For your information, depending on the model you are using, the button will be located either at the bottom or in one of the corners of the Netgear router.
- Once you find the Reset button, press it with the help of an oil pin or paper clip.
- Wait for approximately 30 SECONDS to 1 MINUTE.
- As soon as the networking device resets, it will start rebooting.
Are you done resetting the Netgear router? Good. Now, set it up from scratch by using the default Netgear router login password. The username of the router is by default ADMIN.
With that, we are summing up the guide written on how to troubleshoot the Netgear router internet light amber issue. We hope that after following the hacks given above, you will be able to turn the color of the LED from amber to green.